DIY drill accessories - photo and diagram
Contents ✓
HOW TO MAKE A DRILL COMFORTABLE
To drill holes for fence posts or foundations, I use a hand drill. I do not use the soil from the well, because I support the concrete. In order to quickly and accurately remove it, he made a simple tray. And for the preparation of high-quality solution produced a convenient mixer.
HOLIDAY TRAY
Prepared a design drawing (see fig. On page 14). In a sheet of plywood 10 mm thick, a jigsaw cut a hole slightly larger than the auger diameter, in my case 210 mm. I screwed a sheet of metal 50 mm wide with a screw around the perimeter - the tray is ready.
At the place where there should be a hole, I put the tray and, setting the screw in the hole, I start to drill. The extracted soil falls on a sheet of plywood (photo 1), and the side of a strip of metal does not allow it to crumble back. When the tray is full, pour sand into the cart (photo 2) and continue drilling.
Note
The size of the tray depends on the diameter of the auger auger and is selected individually.
MIXER DRILLING PACK (photo 5)
A metal tube with a length of 100 cm and d 32 mm welded perpendicularly two strips of length 50 cm - one to the end, the other - approximately in the middle.
The crossbar connected to each other segments of metal bar d 6 mm. He welded a ring to the lower crossbar. Additionally strengthened the device by connecting the pipe with a ring with crossbars from a bar.
See also: How to make a homemade drill - photos and scheme
CONVENIENT DRILL WITH OUR HANDS - PHOTO
DRILL OWN HANDS - VIDEO
© Author: Sergey Khomyakov. Photo author
TOOLS FOR MASTERS AND MASTERS, AND HOME GOODS ARE VERY CHEAP. FREE SHIPPING. THERE ARE REVIEWS.
Below other entries on the topic "How to make your own hands - a householder!"
- Do-it-yourself screed for a metal cable
- Self-made knife sharpener with your own hands
- Ideas with your own hands for storing magazine files + drilling template
- Cane do-it-yourself mop cane
- Do-it-yourself suspended wood splitter
- Wheelbarrow-sneguberschik own hands (photo + design drawings)
- Do-it-yourself casting and vacuum installation as a substitute for a 3d printer at home
- Do-it-yourself grinder table attachment
- Do-it-yourself mini-emery from a hard drive (HDD)
- Adaptation device for plant transplantation by own hands
Subscribe to updates in our groups and share.
Let's be friends!