5

5 Comments

  1. Alexey Viktorovich AFANASYEV, Vologda Region, the city of Kirillov

    I will share simple advice on how to unscrew a rusty bolt. Its essence is heating.
    This is done in various ways: you can use a soldering iron, but ideally a torch or a blowtorch. It is necessary to warm more strongly, then the chances of unscrewing the rusted bolt will be higher, the main thing is to act while it is hot, that is, heat and immediately unscrew. Almost always, such an operation ends successfully.

    Reply
  2. Nikolay DNIPROV

    We repair the floor with our own hands

    In the corridor of a country house, a plank floor has rained in places. I sifted the birch sawdust remaining after harvesting firewood, mixed it with PVA glue, added some water. With a spatula, filled the plastic mass of the gap between the floorboards, and when everything is dry, polished fine sandpaper. Simple, economical and reliable!

    Reply
  3. Guest of the site "With Your Own Hands"

    The long ladder is inconvenient for manipulations alone, even if it is not very heavy in itself, like, say, modern metal stairs from a hollow profile.

    For example, when you try to put it vertically on a flat surface, the lower supports will “run away” from the lift. To avoid this, it is enough to tie a rope, a sling, etc. to the bottom rung and lift the ladder, stepping over this rope. If the ladder needs to be carried often, you can use a piece of rope with a hook and store it just by hooking it at one of the upper steps.

    jpg

    Reply
  4. Guest of the site "With Your Own Hands"

    Before you install, the ladder must be delivered to the place. As practice shows, the metal composite three-section ladder is quite possible to lift and move alone, but together it is much more convenient. And if your staircase is wooden, then one can be, to put it mildly, inconvenient.

    The problem will be solved by a small wheel, preferably already on the mounting bracket. It should be fixed in place using the available tools.

    Reply
  5. Guest of the site "With Your Own Hands"

    Saving holey hose
    A hole appeared in the watering hose. I wiped this area dry, cleaned it with a sealant, and wrapped it tightly with tape to prevent folds. Natalia GOFAROVA

    Reply

Leave a Reply

Your email address Will not be published.